http://www.optosupply.com ver c.0 x x e e o o n n 1 1 p p o o w w e e r r y y e e l l l l o o w w l l e e d d osy5xme1c1e ver c.0 features outline dimension highest luminous flux super energy efficiency long lifetime operation superior esd protection superior uv resistance applications read lights (car, bus, aircraft) portable (flashlight, bicycle) bollards / security / garden traffic signaling / beacons in door / out door commercial lights automotive ext " o p e f
$ b u i p e f
6 o j u n n 5 p m f s b o d f ? n n & 4 % 1 s p u f d u j p o % j p e f " o p e f $ b u i p e f # b d l 7 j f x absolute maximum rating 5 b
directivity item symbol value unit dc forward current i f 400 ma pulse forward current* i fp 500 ma reverse voltage v r 5 v power dissipation p d 1200 mw operating temperature topr -30 ~ +85
storage temperature tstg -40~ +100
lead soldering temperature tsol 260
/5sec - *pulse width max.10ms duty ratio max 1/10 electrical -optical charac teristics 5 b
forward operating current (dc) item symbol condition min. typ. max. unit dc forward voltage v f i f =350ma 2.0 2.5 3.0 v dc reverse current i r v r =5v - - 10 a domi. wavelength d i f =350ma 585 590 595 nm luminous flux v i f =350ma 40 50 - lm 50% power angle 2 1/2 i f =350ma - 120 - deg 80 forward current, i f (ma) ambient temperature, t a ( `
100 60 40 20 0 200 150 100 50 0 250 300 350 400 r j-a =60 ` /w r j-a =50 ` /w r j-a =40 ` /w r j-a =30 ` /w note: don?t drive at rated current more than 5s without heat sink for xeon 1 emitter series. led & application technologies
http://www.optosupply.com ver c.0 x x e e o o n n 1 1 p p o o w w e e r r y y e e l l l l o o w w l l e e d d osy5xme1c1e ver c.0 handling of silicone lens leds notes for handling of silicone lens leds please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. the leds should only be picked up by making contact with the sides of the led body. avoid touching the silicone lens especially by sharp tools such as tweezers. avoid leaving fingerprints on the silicone lens. please store the leds away from dusty areas or seal the product against dust. when populating boards in smt production, there are basica lly no restrictions regarding the form of the pick and place nozzle, except that mechan ical pressure on the silicone lens must be prevented. please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) led & application technologies
|
